Connecting and Selecting an Audio Device
Headphones connected directly to your Mac: Sound should automatically come through your headphones if they are plugged directly into the headphone jack.
External audio interface: Connect your interface via USB as you would your MIDI instrument. Ensure any necessary drivers are installed, and then select your device as your audio output in Melodics’ settings.
Your instrument may also act as an external audio interface. Similarly, you'll need to make sure any necessary drivers are installed, and then select your device as your audio output in Melodics’ settings. Tip for V-Drums users: set the USB Mode on your V-Drums module to "VENDOR" to enable audio over USB.
Tips to reduce audio latency (delay)
Typical macOS based machines are well optimised for low latency audio. If you are experiencing latency on your Mac, try the following.
If you are using your Mac’s built-in speakers or built-in headphone output:
Latency when using a Mac's built-in audio output is not common. Instead, you may actually be experiencing latency from your MIDI instrument. Check your MIDI instrument connection. Refrain from connecting via a USB hub and connect directly to your Mac. Try using a different USB port on your Mac. Try using a different USB cable. Short, high quality USB cables perform better than long, low quality cables.
If you are using an external audio interface:
Some external audio interfaces will have adjustable buffer settings. Go to your audio device settings and reduce the buffer size. Check with your manufacturer or user manual for more information. The buffer determines the amount of time it takes for your computer to process audio. The lower the buffer, the lower the latency, however if you go too low you might experience audible distortion.